 |
 |
   |
|
 |
|||
 |
|||
 |
|||
 |
 |
 |
|
|
 |
 |
 |
 |
 |
 |
 |
 |
| In the May 2002 edition of Signs Canada magazine on page 26, there is an article on selling to government accounts. Featured in this article are the two signs shown above. The design work for these signs were not done by us but the routing of them was. Both signs were milled out of SignFoam by our 49" x 40" routing table. All of the toolpathing was done by our company president, Jason Robinson, in Cadlink's EngraveLab 3D Pro. The signs were coated with paint primer and then painted in colour. This is a typical example of the high end signage that can be created with the CNC Routing systems. |